README.TXT for the CAG Bootp Server
Revision A.01.02
Agilent Technologies
copyright 1999

You have just completed the installation of the bootp server that will allow you 
to provide IP addresses and required settings to HP analytical instruments, so they 
can communicate to the Agilent Cerity QA-QC Software using the TCP/IP protocol.
If your IT department already runs a bootp server, confirm with them the operation
of the bootp server.

You only need to configure one PC with the bootp server for your local subnet.  Additional
instruments may be added, even if they are not running on the same Agilent Cerity Software.  
When you power on the instrument host name, IP address and configurations will be automaticly
down loaded to the instrument. After the instrument is configured you may close the bootp server.
You will need to run it again if the instrument is power cycled.